Aomway Mini 200mW VTX and FPV tuned 600 TVL combo

The Aomway Mini 200mW VTX and FPV tuned 600 TVL combo (I’m not using this camera anymore, I just use the Aomway 200mW vtx now)with match Plug and play cables
The Aomway Mini video transmitter packs 200mW of ultra-clean 5.8GHz power in a micro sized video/audio package! A must have for those looking to save size and weight while still getting good performance. The Aowmay is transmitting a full range of 32 channels and only weighs 6g. It’s perfect for a wide range of aircraft, especially small models and more!  They are working perfect with my Fatshark Attitude V2 Goggle.
Aomway’s new Mini 600 TV lines camera with built in microphone is the perfect plug and play Camera for Mini to large models needing a small but yet quality camera made for FPV applications.
The camera has a shielded A/V cable and standardized 5 pin connector that is plug and play with most video transmitters. The CMOS FPV tuned sensor is great in all light conditions and even comes with a lens adapter if you want to change the FOV.

Update

I’ve been using on my ZMR250 with great success, it perform better than my Fatshark 250mw.  But the camera was not that good, I’m now using a camera from surveilzone.com that work perfect with the 5v comming from the tx without any line…

Nice little package with 5v output for camera make for a compact mini quad

Nice little package with 5v output for camera make for a compact mini quad

Features:
• Micro sized and light weight – perfect for use with small models
• 32 channels: Cover A, B, E and F bands
• Transmitter frequency: 5645-5945MHz with 200mW power output
• Built in microphone
• Shielded A/V cable
• 600TVL resolution
• Mini sized at just 15x15x23mm

TX Spec:
Modulate: Wideband FM Modulate
Video Format: NTSC/PAL
Output Impedance: 50 Ohm
Output Power: 23~24dBm
Channel: 32CH
Operating Voltage: 7V~24V
Supply Current: 190mA
Operating Temperature: -10~85 Video Band Width : 0~8.0 MHz
Audio Carrier Frequency: 6.5MHz
Video Input Level: 0.8~1.2 Vp-p
Video Input Impedance: 75 Ohm
Audio Input Level: 0.5~2.0 Vp-p
Audio Input Impedance: 10K Ohm
Connector: SMA (NOT RP)
Dimension: 26mm x 23mm x 8mm
Weight: 6g (without antenna)

 

Cam Spec:
Image sensor: CMOS
Lens: 2.8mm
TV system : Pal
Horizontal resolution: 600TVL
Picture elements: NTSC
S/N Ratio:>=45d
Usable illumination: 0.5Lux
Scanning system : NTSC
Net weight:13g
Cable length: 25cm
Size : 15mm x 15mm x 5mm

Connector: JST

Note: Feedback has shown that transmitting distances in the vicinity of 1500m (open area) have been achieved according to the company…

aomway vtx 200mw

At 6 grams, it make a nice option for Mini Quad!

 

Aowmay VTX nicely packed!

Aowmay VTX nicely packed!

aowmay vtx

I used a needle to move the switches to my Fatshark Attitude V2 Goggle

Aomway Mini 200mW VTX and FPV combo

Aomway Mini 200mW VTX and FPV combo

Aomway Mini FPV Tuned 600TVL Camera (NTSC 2) at 11grams

Aomway Mini FPV Tuned 600TVL Camera (NTSC 2) at 11grams

It come with a manual with all the frequency and switches position. I finf that using a needle is the best as you don't have to remove the heat shrink.

It come with a manual with all the frequency and switches position. I finf that using a needle is the best as you don’t have to remove the heat shrink.